Hello, working with projects, when switching from one project to another, the setting of the genetic settings that is displayed is incorrect.
I created two projects called:
EU-H1-3TEST
GEN5
the initial settings I selected were:
for EU-H1-3TEST
Crossover probability = 50%
Mutation Probability = 20%
Generated decimation coefficient = 3
for GEN5
Crossover probability = 90%
Mutation Probability = 30%
Generated decimation coefficient = 2
Now that I wanted to check the parameters used, I switched from the GEN5 project (see photo number 1) to the EU-H1-3TEST project
(see photo number 2). Later I returned to the GEN5 project and shows the parameters of the EU-H1-3TEST project (see photo number 3).
Closing and reopening SQ and going immediately to the GEN5 project turns out to be correct as I initially created it.
If, on the other hand, I close and re-open the SQ and immediately open the EU-H1-3TEST project, EU-H1-3TEST has the correct settings, but passing to the GEN5 project, GEN5 shows the EU-H1-3TEST settings.
Try scrolling through the various projects to see what happens.
I have 2x Intel Xeon - 32 thread total - 64 gb RAM and i use for this SQ istance 20 thread and 24 gb of RAM
Bye