129 dev 6 Sometimes Build does not stop after clicking stop
For some reason, sometimes, my build keeps going even though I stopped it. I dont have software to capture this on video just yet but you can see the timestamps of the log vs my local time on windows.
The buttons have changed as if SQX stopped but the actual process continues on. I believe this is causing a memory leak as well. Also, because the buttons are showing what they are like in the rest state, a mouse hover over the stop button shows up as a red cancel icon. So I cannot press stop because the UI thinks the build process has stopped.
This is a second instance of SQX so I don't know if that has anything to do with it. My first instance of SQX is not running while this one continues to run.
-
Votes +1
-
Project StrategyQuant X
-
Type Bug
-
Status Fixed
-
Priority Normal
History
KL
KL
kainc301
11.07.2020 17:38
After restarting SQX, it works normally again. If I figure out the steps to reproduce this, I will update this.
E
Emmanuel
12.07.2020 16:37
This happen to me as well specially if I stop less than 30 seconds after I start
E
MF
Mark Fric
15.07.2020 13:43Status changed from New to Waiting for information
there was a bug that might have cause this - it happened when you pressed Stop during the data feed preparation phase, before it actually started generating. This was fixed.
Khari, if it wil happen also later during the build please let me know, otherwise I think it should be fixed.
KL
kainc301
15.07.2020 14:18
I haven't seen it occur when I'd stop the build process after letting SQX run for a few hours so I believe you may have identified it.
MF
Votes: +1
© Copyright. All rights reserved. ProjectPanel.com
